HÜPPE Price Catalogue 2023

269 Warranty Conditions Our products are guaranteed against manufacturing defects for 5 years for bathtub and boat bodies and 2 years for other parts. For the warranty to be valid, the signed warranty certi cate and the identi cation label on the product (on the underside of the acrylic plate) must be retained. Cases where the warranty does not apply a) Failure to follow the installation, use and maintenance instructions for transport, assembly, use and maintenance of the product b) If the electrical system does not meet the conditions in the Electrical Connection Speci cations on p:263 c) Failure to provide suitable conditions for the storage of the product and consequent damage d) Deformation, damage, etc. on the product due to an external factor after the delivery of the product e) Dust, sand, gravel, etc. in places under construction after product delivery. foreign materials entering the system and causing blockage in the system f) Failure to provide ventilation / access gap in recessed applications g) Failure to use the product for its intended purpose h) Removing or damaging the product identi cation label under the product i) The use of materials other than the recommended products in the cleaning of the product and as a result, deformation, dullness, etc. on the product surface. j) Damage to the surface due to contact of ammable materials such as cigarettes etc. with the surface of the product k) Damage due to lime residues Usage and Care Recommendations The following instructions must be followed to prevent damage or surface deterioration of the acrylic and metal parts of the products. a) The inside of bathtubs or shower trays should be cleaned with a soft cloth and a neutral, non-abrasive liquid cleaner. In the cleaning of the product; synthetic bers, hard scratching cloths, cleaning wires, abrasive detergents (solid/liquid), bleach, salt spirit, alcohol, acids for household use, acetone or other solvents that may damage the surface should never be used. b) Cleaning agents other than bath foam, bath oil, etc. produced especially for hydromassage systems should not be used. These products can damage the system because they do not dissolve well. c) Damage caused by lime residues is not covered by the warranty. If the water used is too calcareous, it is recommended to install a water softening system. In the event that this is not possible, diluted warm vinegar can be used to remove limescale residues that may form in the hydromassage system. (This application is only recommended for hydromassage system elements.) d) Care should be taken to ensure that the product is installed in such a way that it is not exposed to intense ultraviolet rays such as direct sunlight and solarium. e) Minor scratches that may occur on the acrylic surface can be removed with a soft sandpaper, depending on the depth. f) It is recommended to clean your hydromassage system periodically with clean water or by circulating the system with disinfectants specially produced for hydromassage systems. Installation and Technical Information Shower Tray / Bathtub / Hdr Bathtub Technical Information